Recent content by Dougncrew

I went ahead and bought some vinyl runners and will give them a shot. I just thought about the 5 gallon bucket this morning. Changing ramps is possible but way inconvenient. I will post the results.

I had small receivers made so when i drive they are tight to the side but when i launch or retrieve they slide a foot in each direction.

I will start with why I am asking. The boat ramp I use is too short. in order for me to get the bunks wet all the way to the front my tires fall of the end of the ramp and I am destroying my trailer when I pull it back up and on. I have bent my fenders back til they are touching the tires. So...

This is specifically regarding sleeping on the boat at lake Havasu AZ. Does anyone know if you can anchor off shore and sleep on the boat. Is it ok in a cove? Any advice is appreciated.

Went to the Topock Gorge this weekend. what a beautiful place,

Nice... and I do need new tires......

With the ramps I use I have to get my back tires well into the water. But I have still been thinking about this and I am willing to bet it is mostly people that launch alone. They get the back of the vehicle so far done and when they exit the vehicle some how the boat lifts the back end of the...

I am always nervous as well. I only have a 2 wheel drive and I have had situations when I am trying to pull the boat out and I have started sliding back. Next time I think I will try airing down my rear tires and have people on my bumper.

I was looking at videos of a location I want to visit and in the "suggested" videos I saw one one that was about launch ramp disasters. I watched them pull several trucks out of the water that had been completely submerged. Most of them still had the trailers attached. But I noticed that almost...

We have a 2009 2575 RCW and we were out in it a few weeks ago and we ended up parked next to what I thought was the exact same boat. But the owner said that he had never seen a Bennington with thru the transom exhaust. Is it that uncommon?

Dougncrew (53)

I just happen to have some left over from a project i had. I bought them from a place call coast aluminum.

I see now. mine is pop riveted on

I found removing the sides easier than the under skin.

I know this is an old post but will I stain my driveway if I use this on my toons and rinse in my driveway?