Recent content by Rcornbleet

  1. R

    Engine stutter.

    Try some sea foam
  2. R

    Fuel consumption 200 vs 250 or 300hp

    Have 2013 2550 rcl with a 300 mercury verado. Fuel consumption is a wash depending on how u use the boat. Usually it’s a few guests and run about three quarters throttle at cruising speed, but do run full throttle when I feel the need to get somewhere. Since I do not pull skiers, tubers, etc...
  3. R

    What model do you Own and What is your age?

    51 … 2013 2550 rcl. 300 mercury Verado. Ohio river Kentucky and Kentucky and Barkley lakes
  4. R

    Cleaning engine lower unit

    Agree with big kahuna. CLR is what I use on my motor
  5. R

    Depth/Fisfinder

    Went with the Garmin striker 4. The connections are compatible and is a near fit. Just had to make some small modifications on dash
  6. R

    Depth/Fisfinder

    I have a 2013 2550 rcl. Want to replace the original Garmin echo 100 depth\fish finder that is mounted in the dash console. It is no longer functioning and is a discontinued product. After researching, I found the Garmin striker 4 possibly would be the best size for a proper fit in the dash...
  7. R

    should it be faster 2022 Benning ton rx sport 400 verado

    I have a 25 foot rcl with a 300 mercury verado. It is equipped with a 15 pitch prop. These motors are designed to turn higher Rpms. At wot I’m turning 6300 + rpms and a top speed around 47 to 48 mph. Don’t sacrifice rpms as to gain or lose mph.
  8. R

    grill mounts for flush panels?

    I have a kumma grill that mounts on rails. There is hardware available on Amazon that will fit over Rails. Grill, hardware, and quick connect all came from amazon. Works very well and worth every penny!!...
  9. R

    Pontoon guide ons

    I have a 2013 2550 rcl tritoon with the esp package. Was wanting to know if anyone has had any experience/info on the Extreme Max heavy duty pontoon guide ons. Would they be compatible for a center tubed pontoon and how well they worked.
  10. R

    Ignition Housing Question

    Shud just pop off. My ignition also fell out and fell into console while on water. Had to pop the outer ring off with a flathead screw driver. Once off was able to tighten nut that holds the ignition.
  11. R

    Upgrading to a new motor

    I also agree. Don’t think you will benefit much with with the upgraded motor.
  12. R

    Seats separating at stitching

    Yes. I have a 2013 2550 rcl. The seams on my cushions were separating in the back. Bennington replaced both cushions no problem!!.....
  13. R

    Rcornbleet

    Stating specs.
  14. R

    Rcornbleet

    Wot rpm around 6300
  15. R

    Rcornbleet

    2013 2550 rcl esp, 300 Verado Pro, ss prop 15, 48 mph
Back
Top