Back to the main site

Circuit Breaker

J

Jetman

New Member
Messages
3
Reaction score
1
Hello Everyone,
I am finally getting around to installing docking lights on my 2008 Sedona LC21 pontoon boat. I discovered that the wiring was already in place near the navigation lights at front platform. The light on the docking light switch at the helm comes on and I detected 12 volt's at back of switch where wires exit, but I am not detecting voltage at end of wires for docking lights. It is my understanding that Bennington used individual circuit breakers for each circuit on these boats. Can anyone help me locate the circuit breaker for the docking lights? I have searched online for this information to no avail.

Thanks in advance for any helpful information you may provide.

Jetman
 
I feel so foolish! The circuit breakers were right in my face. The one protecting the docking light circuit wasn't tripped, so I still haven't diagnosed my problem.

Jetman
 
Did you trace the wires you found back to the switch?
 
Hello SEMPERFI8387,

Yes, after scratching my head many times, I finally removed the tape and conduit covering the wiring and discovered the hot wire wasn't black with an orange stripe (as observed at the back of the switch) but was gray with a blue stripe. After checking the hot wires at the switches, I discovered the switch for the live well had a hot wire that was gray with a blue stripe. Problem solved!!

Thanks for your reply,
Jetman
 
You must log in or register to reply here.
Back
Top