Sampson104
New Member
- Messages
- 3
- Reaction score
- 1
Hi,
I have a new 2018 23RSBA, having an issue with the section of Bimini that is secured within the arch (the small section that the overhead top zips onto). It pulls out from the track that is recessed within the arch and I have gaps in each side. I’ve fed it back in but the same issue arises again. I have to run the rear support arms of the framing in the far up position so it doesn’t have any tension on it or it will pull the section out of the arch. Looking to see who else’s may have a fix for this. If I do anything over 23MPH the wind will cause it to happen.
Appreciate your time in advance folks!
I have a new 2018 23RSBA, having an issue with the section of Bimini that is secured within the arch (the small section that the overhead top zips onto). It pulls out from the track that is recessed within the arch and I have gaps in each side. I’ve fed it back in but the same issue arises again. I have to run the rear support arms of the framing in the far up position so it doesn’t have any tension on it or it will pull the section out of the arch. Looking to see who else’s may have a fix for this. If I do anything over 23MPH the wind will cause it to happen.
Appreciate your time in advance folks!