I had the same thing happen. It went through the boot(protective cover case) and the Bimini. Found that even though my boat was on an air lift, as they adjusted the dock with rising and falling lake levels that my back protected Bimini was actually touching and rubbing the roof causing what...
I have a 2574 RFS elliptical "3 tunes" with a 250 four stroke Yamaha and have been to 45 MPH with out pushing it all out. But like others, I can almost watch the gas gauge dropping, so I don't go there often.
I appreciate the feed back. My dealer called yesterday to say they were on their way to fix. This has been the only blemish on a otherwise killer boat.
Any one having problems with the quality of the arm rests on the fishing seats? I have a new 2574 RFS and one of the arm rests pops out of socket with little pressure. The dealer has ordered a new one for the boat but just wondering if this is a common occurance for any one else.
I saw this concern expressed earlier today on the Forum and it is also a concern of mine. Can you guys design and manufacture an optional cover for the extended deck on the back of the tritoon? I have ordered the faux teak throughout the boat. The rear of my boat, although under a factory...
I too am concerned about the deck extension and mine too is faux teak. I intend to ask my dealer to recommend a solution. If not protected from the sun you can imagine what 3+ years at the end of a covered slip will look like. The rear of my Bennington will face the West. My old ski boat...
Thanks, that's what I was thinking just wanted confirmation. I have been landing a 20' ski boat in a 24' slip. The new pontoon will be a much tighter fit.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.