Mine has 3 zones but that might be different than yours. My boat came with the RGB wiring diagram that shows how it is set up. I tried to find a source for just the LED's for the cupholder but was unable. If you don;t have the right kind, they may not illuminate correctly so i bought the...
No problem. Let me know if you can where you got the side lighting components. I wouldn't mind adding that using the last un-used zone on my system. I am curious to know where you got your parts. Thanks so much!
I used this.
Deutsch DT 4-pin Pigtail Kit 14AWG Pure Copper GPT Wire, Made in USA https://www.amazon.com/dp/B07FTBN3RV/ref=cm_sw_r_cp_apa_i_C.-kDb0SR24AJ
I did 2 of the 4 possible for my pontoon. If your boat is equipped as mine, pretty straightforward to install. Just a matter of connecting the 4 wires properly
Not sure how to answer your question but the late model Bennington's with RGB seem to use an RGB contoller and Versicolor system made by ITC Marine. You should be able to research that here. I do know that they make a 2 wire blue only cupholder as I have seen it on their website and available...
I saw them on Amazon but the same unit on Ebay was actually slightly cheaper. That why I went with them. Glad to hear the info helped. In case any one needs it, the link to Ebay units is here...
I'll get some better pictures when I do the install this weekend. The LED strip sits in the plastic groove at the bottom of the cupholder held in by clear silicone. The light from the LED's is transmitted up through the clear plastic to the top.
Stay tuned for more PIC's...
I have learned more since writing this post. The LED itself along with the wiring is the only missing from my boat to get this working. The cupholder is the right cupholder (Part Number 81429SS304) but the cupholder with the LED on the bottom is part number 81429SS304-RGB. I sourced 4 of...
Just got my new 2019 Bennington a few weeks back so I am exploring ways to make it even better. I am looking for any info that might be out there on adding the wiring to improve my existing RGB lighting system in my 20SSRCXP. I have cupholders that appear to be the lighted type as they have...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.