Recent content by Dan S

Unfortunately a bear ripped apart the bow/gate seat for our 2015 SX21. We left it sit on the shore overnight and I guess it thought it was a large cooler. Anyway, I’m wondering if anyone has a bow seat in sandstone that they’re looking to get rid of. I live in St Paul, MN.

Thanks for your input. It’s just my belief that the cover is one of the more critical components. What would have been nice at purchase, would have had the option for a better cover made from Sunbrella or Top Gun material. I would have gladly paid for a better cover as an option rather than...

0 of course, but not having to deal with it in the first place would be best. Bennington should have sourced better canvas IMO.

Thanks rodsfields, I’ve done a bit more reading and it appears that it should be but what a hassle.

I received delivery of my 21SX Bennington early May of 2015. Burgandy mooring cover with snaps. It appears I’m having major failure of the material. First there was a small stretchy looking hole behind the helm seat and I just wrote it off to a stick falling from a nearbky tree. Then there...

Normally that would be my first choice but I repaired one of them last year because it was easier. Plus the way they had constructed it was not very good. I forgot the adhesive I used on the first one.  I ordered a second rectangular top to replace the kidney shaped one in the aft part of the...

I have two rectangular matte finish tables on my 21slx. Both have come apart - the top from the bottom 1/2. The factory used some totally    ineffective silicone adhesive to hold the two 1/2's together. Anyway, I want to glue them back to together properly. Does anyone know what type of plastic...

Yup, I just purchased all my winterizing supplies but what should I spray on the Sharkheide coated toons before power washing?  How strong of a spray can I use on the Sharkheide? Thanks

Yes, I thought of the stick on tape but thought that might peel off after awhile.  Thanks.

Way too expensive given where the trusses are and the pitch of the roof

On my last boat, I installed some flip down cup holders that worked very well.  It appears that you have plenty of space to put one to the left and down the side of the helm from your existing cup holder unless the slope is too severe.  Try the link here -   ...

I have a very short haul to the launch from our pole building, about 2-3 miles each way.  I did a test pull a couple of weeks ago including highway at 60MPH and everything went very well.  Really, no one else uses a scissor trailer on this forum? My first choice was a bunk but I had to go with a...

Hello.  I purchased a Trophy/Titan 22' scissor trailer for my 21SLX.  The trailer is only 3 years old but starting to rust on the top of the support beams that the the pontoon deck rests on.  I'm considering rolling or brushing pick up bed liner onto the tops of these supports so as to prevent...

I'm at the point where I'm purchasing a trailer for my 21SLX with a 115 Yamaha with undersheeting and open strakes. Originally I was going to purchase a bunk trailer but I don't have the height through the doors on my pole building so scissor trailer here I come. I'm going to purchase a trophy...

Is it ok to use the eye hooks on the front of the pontoons to tie the boat to the front of the scissor trailer? When the boat was delivered to us, on a scissor trailer, it was tied down with a heavy duty ratcheting tow strap to the frame of the trailer in front and wrapped through the pontoon...