Recent content by DanielG

Thanks. Just reached out to them and sent pics and they responded right back. They are going to ship out the replacement part today. No charge. Love it!

I'm hoping someone here can help me. I don't know what you call these things, but the slide mechanism on my captains chair fell off yesterday. Upon inspection one of the plastic clips that hold it in place is broken. Pics attached. Can anyone tell me where to get these, what they are called or...

I popped through the floor and then ran the wires down the outside edge of the boat then back in and up under the helm. I put the wires in some wire wrap and secured it to the exposed plywood on the edge. No need to remove the under skirting underneath. It was easy and if you have someone...

Below is a portion of my response on page #1 of this thread about Running Wires. It was super easy. Hope this helps.

IMHO, it's kind of like looking at TVs in Costco or Best Buy. If we compare the features of each TV we tend to lean toward wanting the added features, brighter picture, etc... , but the irony is when you get it in your home and there's no comparison beside it you become totally content with it...

I got the Portland 1750psi, little electric one. I turned the nozzle to the widest spray (less pressure) and held it up off the floor 8-10". It did a great job, especially on the lower plastic molded portion of the seats. I even hit a spot or two on the seats themselves. Just be careful not to...

Ok, went ahead and did it. Light pressure and held it off the flooring about 8-10". Worked perfectly and looks as good as the day I bought it. Spray nozzle on the water hose might have done just as good but the air pressure helped to blow the dirt in the direction I wanted it to go.

Hey guys, A week or so ago I took my little Harbor Freight "el cheapo" pressure washer and washed down the mooring cover to remove all the pollen and then gently pressure washed the side panels and front and rear deck of the sawgrass flooring that were exposed while cover was still on. I got a...

Thanks for the tip. I will certainly check them out.

Potomacbassin’ your words are ringing true. I'm thinking a paddle and an anchor might be best. lol Seriously, I might be better off just springing for a used jon boat and putting a small trolling motor on it. Thanks for the input guys.

Hey guys, so I've searched and read the forum and can't quite find the info I need so here goes. During the whole Pandemic my college age son and I have started fishing around our dock to pass the time and enjoy it. We'd like to venture out a bit so I tried going on our Benny 22SSRX a couple...

That looks pretty cool. I'll check it out.

Hey folks, I saw some older posts about this but haven't seen anything recent so I'd like to see if there is anyone who can share ideas on this. I am at the point of getting our fully covered 28x30 dock wired by a licensed electrician for lighting and power for my boat lift. I'd like to get...

Update on my SeaStar installed by the dealer in my area. Apparently there was air in the line somehow which caused us to have to rotate the steering wheel dozens of times in order to get a little response. It also needed a very small amount of P/S fluid. Nothing major but shouldn't have needed...