Recent content by DLSNFL-1

We use a 2007 Turbo Honda Aquatrax as our dingy to run between the lake and cabin.

I have a 2275GCW and love the back loungers. Thats the whole reason we bought this design. We find there is no problem when 'under way' with conversation (quiet 4 stroke) as two people each can sit on them, but best is when we are just floating and the sun is just right, and the beer is just...

Did you ever get your items (Miller Marine) fixed CLRD??? I got a phone call out of the blue from the guy who fixed my steering issue at the landing of our lake, and he was in the area and had a part from a re-call in the Yamaha fuel system. Got directions to my cabin and replaced it on the dock.

We sold our land locked house and are currently looking for a home on the lake. So it effects more than work!

Thank you to everyone for the information.

First thought was that, but no cell service on the lake.

I was out on our lake watching fireworks over the fourth and it became clear to me that it would have been useful to me if I had some sort of help getting back to dock after the sun goes down. Our past boat (run about) 24" draft always had me worried about losing the lower unit due to some...

Just for reference, my cover is so tight that it is difficult to get fingers behind the snaps when installed. Hand and finger strenght isn't what it used to be. Too much hard living.

Yes I do the same. I install the cover, really have to pull the cover over the ends....and crawl back in and install the poles. I am 6'-4" 290lbs so it is quite an effort. Dealer responded that I bring this to a canvas shop and have it repaired and they would pay me back. He also said he was...

Shore Station vertical lift. So I have posts to deal with. And a cross breeze will send me into them if not careful. We now unload at dock and I can walk the boat into the lift without trouble. Future plans are for a cantelever without the posts where I can drive the boat right onto.

I have a 2013 GCW 22' and have had trouble with the Cover. First the plastic vent cover was not installed correctly over the pre-cut holes...thats fixed but now its a snap problem. Several have broken off from the cover itself and are still attached to the boat. Also some snaps are bent in the...