DVW's latest activity
-
I decided to take the Door off the Galley. The Door is not well thought out. I like how when it’s closed it stops that little bit of... -
DVW replied to the thread Has anyone replaced the drivers seat pedistal?.You will not have to worry about loose nuts on the bottom of the raised console floor if you know how to raise the console if needed...
-
-
DVW replied to the thread New Snap in carpet time.Single piece carpet looks great. Did the boat originally come with snap in carpet? Looks high end. What model is the boat? Also looks...
-
The part came out great way way stronger then the Orignal and will do the job
-
DVW replied to the thread Custom Boat Railing for Grilling.Fancy editing of your photos. Make sure you consider port side boat access and dripping grease. Attached is a photo of a past boat with...
-
-
DVW replied to the thread Motor vibration.Measure eccentricity at the most rearward circular end of the prop. You are trying to determine if you have a bent shaft.
-
If changing props didn't affect it and everything else checked out, the obvious answer is bent prop shaft or some other issue in the...
-
DVW replied to the thread Motor vibration.A bent shaft is perceivable when you rotate the prop by hand. I had one that was obvious but still somewhat usable. Measure runout by...
-
DVW replied to the thread Fuel fill vent.As Jack said your dealer is the best source. This tank top device is a combination tank overfill sender and tank vent. It’s purpose is...
-
DVW replied to the thread Motor issues.Your terminology confuses me. The term cranking the motor over means rotating the motor with a external power source in order to ignite...
-
DVW replied to the thread Motor issues.I am going to assume that when you say “it wouldn’t crank up” you mean the motor will not start when the starter cranks over the motor...
