Recent content by franklyfrank

I have a 2021 RX25SB with a Yamaha SHO 250 V6. I can easily do 45 mph at 5000 rpm with 4 or 5 people and a full fuel tank. I wanted a 300 HP but the salesman talked me into the SHO and I am glad I listened. When normal cruising most of the time the motor is silky smoot, quiet and sips the fuel...

It s working flawlessly. I left the original Garmin in place and the readings are mostly in 100 percent sync. The alumaducer is more reliable when running at higher speed .

I should have stated that the Alumaducer is a TROUGH the HULL transducer and it is very simple to install. Pick the location sand or wire brush it and wipe it clean with alcohol or such and apply the special Epoxy to glue it in place.

I finally got around to complete this DIY project planned last year . I got bogged down delaing with the aftermat of Hurricane Helene and Milton. The entire project took me about 3 hours and cost about $ 300.00. Could have completed it quicker had I been a midget Hudini . Getting to the back of...

What brand did you get ? I am looking for a front bimini for our 25RXSB and the Factory only offers powered and I prefer a manual .

The cover for our boat got ripped to shreads by Helena and than Milton. Where to order and wit clips or snaps.

Where did you get your cover with the Clips ?

The Factory Cover on our 2021 25RXSB literally coming apart at the seam. Would that be covered under the warranty ?

I am thinking of installing it in the center tube or in the motor mount. Will be contacting Bennington to see if there isva pathway from the center toon to the helm.

Its glued to the hull inside. Like I said I installed one in my previous boat in bilge are worked beatifully. No they developed a tranducer that works inside aluminium hulls including pontoon tubes. I called and sent them the tube thicknes of my pontoon and they confirmed that it will work no...

I installed one last year and love it. Better sight coming into dock. I use a life safety pad under my feet to make it more comfi in the up position.

The Alumaducer is a through the hull transducer. No need to cut a hole. Its a new product that can read through aluminum boats and pontoones. I installed one on my previous 32' Offshore boat worked like a charm since it was front of all the turbulace. Accurate at any speed. This is my next...

I am thinking about installing one of these in the center Tube. Has anyone done this.

I have been covering our RX after every use since I can't build a roof over my boatlift in the FL community we lieve. I noticed the threads comming off the cover in bunches. Is this also a warranty Item ? It came with the boat from the factory.

Yes sir, that and this general area has been my boating paradise for the last 30 years. Pontoons have become very popular around here. My triton handles the rough water as good as my previous 32' offshore fishing machine.