Recent content by Hunterleej

Thanks! Tom....forgive my ignorance but I'm assuming the 4 x 4 in front goes across under the front of the pontoons? do i need to somehow cushing the part of the toons that are in contact with the 4 x 4 ?

Does anybody know of a video anywhere that will show me how to get my 20' pontoon off my trailer and onto blocks or stands so I can work on the toons? Thanks

06 Bennington......keep it on a lift in my boat house......usually out on the water no more than 4 hrs at a time.......go out about once every 2 weeks...live in Eastern N.C (river)........as soon as we get back from our outing, I put her in the boat house and lift her.......I have noticed lately...

06 Bennington.......if I get a drain valve installed at the rear bottom of each of my two pontoons, will water drain through all sections of each pontoon (assuming there is any water in there) or are the sections somehow blocked from each other? Thanks

20' Bennington with Yamaha T60 HP 4 stroke.......I just replaced my 14 x 11dual thrust Prop with a 14 x 11 that is not dual thrust.......before I try it, I'm wondering if I have made a mistake......will I detect any differences? I do very little reversing....please advise...Thanks

What is the Prop nut size on my 06 Yamaha 4 stroke 60 HP?.......Thanks

06 20' Bennington 60 HP Yamaha 4 stroke 2 toons I'd like to lift it off my trailor and paint my toons....I would appreciate any advice as to how to do it.....I have jacks and jack stands if needed.....no fork lift.....Thanks

what is best way to clean my carpet? mildew and black streaks......Thanks

any good ideas on best way to remove mildew on my carpet? Thanks

When it is not working, neither switch works...when it kicks back in they both work........I saw where somebody said hydraulic fluid might be low or one of the solenoids might be bad....do you know how to check the solenoids?

06 Bennington 20'........I've got a tear in one of my seat backs...I've included a picture......I have a few questions.......does this look like something that can be sewn without removing the seat (my wife is pretty good)...If I have to remove the seat, is there a way to remove just the back or...

20' 06 Bennington with 06 60 HP 4 stroke........last couple of outings when things are all set to go (coolers, Grand kids, etc) my tilt switch hasn't worked.....I can play with a little bit, switching from up to down and after a few minutes it starts to work perfectly.......when it is not...

Thanks guys

I'd like to remove my dashboard and clear up some gauge windows....is this something difficult to do? How do I remove the rocker switches, etc? Thanks

Thanks guys!!