Recent content by JCinNC

Nice!

doesn't work well with 32oz big rum cups though

Has anyone else seen a workaround for this?  The cup holder on the helm cannot be used if the throttle is more than 40%-50%.   I looked for another post but couldn't find any reference to it.

Very easy install.   You don't need to order the kit (the Lowrance uses M3 screws and these can be bought at Lowes or another home improvement stores  I purchased the M3-20 screws (x4) and #6 fender washers + a washer to create a countersunk area for the head of the screw.  Lowes has it all in...

Simple swap-out.  I am thinking about getting a square piece of rubber, gluing it to the underside of the cover and then cutting a new hole.  One of our holes was cut a little too large at the factory and I prefer em tighter ;) We also are sewing the bimini strap into the boot cover.  Will...

It's a glue in.  I want to get it a little larger than it is now so that it extends to the edge of the pocket.  The main reason to extend it is that the strange thing is that it has caused the are around the edges of the pad to almost look burnt.  Must be from the black of the pad getting hot...

Doing the same thing today.  Looks like I will have to trim to area where the Garmin went to allow for flush mounting and run the new wires.  I'm figuring 2-3 hour project.  I'll post images when done.

Anyone know where to get a replacement pad n the pocket on the dah (outlined in red in the image)  I need to replace mine as it has gotten a tear in it.  Only looking for the black foam portion.

one more thing the 3 strap bimini mount did not fit the bimini cover on our 2012 2275GCW.  The bimini was much thicker than it was designed for.  You will need to add a small section of strap, a bungee, or if you know how to tie paracord that will work best.  I will try an post a pic later to...

I actually found them when replacing one of my vent covers.  The new boatvent3 is 10 times better than the boatvent2 that came in the cover.   We are only using the one on the bimini as the birds don't seem to sit on the front for some reason.  I am going to put two of them on my 20x20 floater...

Here ya go guys.  Works great and easy to install and remove as needed http://stopgull.us/us/productes/ Fast shipping too

Thanks Todd I'll call tomorrow. We have 25" toons no wave shield and no lifting strakes.

We do store our boat on the lake but the speed has been the same since it went in brand new. Our boat was cleaned and wrapped over the winter so the toon cleanliness, which I'm sure impacts speed, isn't the issue on this one. Also, I do not think toon cleanliness impacts the RPM on the motor...

Anyone have any ideas on the prop and why we're only getting up to 5200 rpm wot?

Got out on the water tonight and got the numbers 20mph (speedometer and GPS confirmed) 5200 RPM WOT Prop K13 - stainless steel (3 blade)