Recent content by LS14EVR

I have a 250 SHO. It's a 2015 with 300 hrs. on it. I bought it used with 39. Runs Great! Just did another 100 hr service yesterday. And an impeller. Very easy to work on. Just need to break them in hard. Warm up and then run hard. Other wise I've heard they can make oil. But honestly after doing...

Thanks guys. I'm skinned underneath as well with wave shields. These may be some possibilities. I may have to look into running further forward or aft than needed just to use a hole that is already there. Thanks again.

I looked at the cup holders and it's only one color. But my stock speakers were mulitiple so you could change those.

First off, why can't you have blue? So most of the cup holders pop out or are slightly glued in place with silicone. I don't think you can just replace the LED light ring. However, I just replaced all my speakers and the factory ones as well as the ones i put in, all have lights. All the colors...

Can someone point me in the right direction. Looking to fish some wires from one side of my rear loungers to the other for speaker purposes. I have a 2015 R23. I have seagrass flooring in the aft and carpet in the middle so I was thinking of maybe trying to use the trim piece between the two...

Yeah I did some searching around on here and other forums to see if anyone has done this yet. So far I've come up empty. I've got a plan on how I'm going to wire, just need to courage to cut into that back area and hope it's flat enough for the speakers. Thank you for the intrests.

I can't believe I'm the only one looking into this. Nothing? Well, I'll keep you all posted cause I'm getting close to pulling the trigger.

Looking to install a couple 6.5in JL audio speakers in the aft facing area and have them on separate switch. Anyone do this? I've replaced my Wetsounds speakers inside the boat. Planning on keeping the kicker amp. Think I just need to tune it in. I am not afraid to add another small amp for...

I bit the bullet and paid the $100 at dealer for entire new light. I bent my pole and snapped the same piece you did in above photos.

DaveyJ, where did you get your cleats? Are they Bennington? Oh and I had to drill out 3 rivets as well. Just ordered some stainless rivets to replace. Funny, looking at my brother in laws 2013 and noticed someone drilled out his rivets and never put the filler piece back in. Just left it open.

Thank you. Good to know. I think my filler is bolted on. I'll have to take a closer look. Pop up cleats would be great. Shocked Bennington doesn't put them on standard on the upper models.

A friend has a Suzuki 250 on a 25 ft Aquapatio tritoon and it flys. 50+

Hello, this may be my first post. I've looked around on here a bit since I got my 2015 Bennington R23 in 2017. It's a Tritoon with a Yamaha 250 Vmax. So last weekend I noticed my rear cleat is loose. This looks difficult to get to. Any input? Or should I hold off till I take it in for other...

I know this is old post however, so far I'm not impressed with 303 products. The cleaner does next to nothing, the protectant is "OK" and the waterproofing is practically non-existent. I may try the Starbrite. Thanks for the tip.