Recent content by NautibyNature

How do you update it? i was going to put a card for my area in it.

I bought a fish tape and ran it the same route as existing wire. I used a piece of bamboo to pull it from starboard to port, then to the back. Now I just have to wait until the extension gets here, attach to the tape and pull it to the helm.

Yes

@SEMPERFI8387, Splicing would be the quickest and cheapest but I'm not sure if it would cause any interference in the data from the sounder. I was hoping someone here has done exactly what you mentioned with no issues. Garmin says don't cut it, but mattresses also say don't remove tags. I called...

I have the right transducer with a 20' cable that plugs into the GPS. I called hoping I could buy another transducer from Bennington that has a short piece of cable with the screw in adapter that is apparently exclusive to Bennington. Unless you have found a link to the transducer I need with...

Anything particular you wanted me to see there Jack?

I understand now what you mean now. I called Bennington CS hoping I could just buy the ducer I need with the adapter but they don't use the one I need. I need to get an extension and fish tape and try again lol. Thanks for explaining it. I'll pm you if I can't figure it out when I try it.

I'm not understanding how you just followed the existing wire? My boat is on the trailer and I can't see anything under it... It's all closed up with metal attached with rivets. 

I have a 2575Q that came with an Echo 100. I bought a 42dv which requires a transducer change...both are 4 pin so I'm thinking piece of cake... Wrong. The old ducer has maybe 2 feet of wire then there is a screw type connection then that wire goes into the hole above the port toon. Under the...

From Bennington Below is data on 25’ Benningtons with an F300 outboard. Have a good day. F300XCA 1.75 ratio 2550RCB ESP 15 1/2 X 17 SWS II 46.5 at 5,800rpm 13.00% hole # 1 F300XCA 1.75 ratio 2550RCWT ESP 15 1/2 X 17 SWS II 45.6 at 5,800rpm 15.00% hole # 2 F300XCA 1.75 ratio...

Who is running a Yamaha300? What speeds, rpm, and size of prop please. I just bought one and it came from the dealer with a 15 1/4 x 18 and Performance Bulletin on Yamaha shows a 15 1/2 x 17? After 2 hours on the engine wot is 43 mph @5000rpm... I know I am over propped but I may need a 15 or 16...