Recent content by Phoenix618

Attached should be pictures of the fit of my new bunks. The boat is not centered on the bunks perfectly probably because the can’t fall into the V. Only solution I see is to move the bunks up but I will be on the edge of the bunk with the lag bolt. Anybody seen this before ?

The individual bunks are not adjustable other than moving up or down on the v .I think I can remove the bolts from one bunk at a time and bump the bunk up till I get a good fit and reinstall the bolts. I assumed the bolts went in the middle of the bunk.

I will get some next week when we go back to the lake.

I replaced the bunks on my Bennington Bear trailer with new boards and Caliper plastic covers. Now the pontoons do not fit bunks . All the bunks are only touching the pontoons on the upper edge on each side. I’ve only trailered the boat from the water to storage which is 1/2 mile. Hopefully the...

Thanks for the replies. I tried to cross reference the Yamaha to a Mercury and it would not cross reference . Evidently all Mercury fuel water separator filters are made for specific engines and installed on the engine. That’s the reason Bennington uses the Yamaha.

I can see a Yamaha coming with a Yamaha filter but my question is if a Mercury also comes with a Yamaha.

My 2016 with a Mercury 4 stroke has a Yamaha water separating filter. I am the second owner . Did it come equipped that way from factory.

I have a 175 optimax on my bassboat that screams like a banchee between 3500-4000 and a 150 mercury four stroke on the pontoon that is quiet as a mouse.

I need a wiring schematic to use the mood light \ dock light switch for mood lights. All the terminals are used on the switch so hopefully their might  be a connector to hook to.

I need a schematic on a 2016 scwx .  It has a mood light /dock light switch and does not have factory mood lights. With no open terminals on the switch you would think it would have a connector for adding the mood lights.