Recent content by Roo Raft

This may be a better picture of the piece I’m looking for. The wire go thru it and It screws into the pole assembly.

Won’t work. My stern light is not a pole that inserts into the hole. The bottom is what is pictured in my original post. Just looking for that circle “cinch” part that screws into the pole. Or if someone can reference me the exact pole assembly. Bennington item number 017617. I can’t fit it...

I have a perko stern light for my 2018 25SSBXP swing back. I broke the cinch pin that goes into the stern light. Does anyone have a Perko part number or know where i can buy the part. I can buy an entire new stern light pole assembly from my Bennington dealer for $105, but i am just looking...

 So looks like SPS configuration with a 150hp.  Thank you everyone for the info :)

I am looking to see what fellow Bennington Club members have to say about the different performance configurations that are available.  the main use of my bennington is to have family and friends on the vessel and possibly tow a tube every now and then.  have stability and maneuverability...

1Blderbob, are the snaps like these?

One of my bow port buttons got a little pinched and i need to take it out and replace it with a new one.  Does any one know how these bow buttons that snap into the playpen cover are attached to the frame of the boat?   Does it screw in and out? If could not feel anything on the inside edge of...

It wasn't too bad.  Went right up :)  thanks everyone!

I bought my 2016 20SSRX last year and took the Bimini canvas off to clean it and treat it with water repellency.  but I have yet to put it back on for the first time   When I was taking it off, I did note which poles had snaps, canvas zipper areas , etc. I checked the generic bennington...

Hello club Benny!  I recently lost the nylon strap along with its two side release buckles that snap into the ones that are fixed to the play pen cover.  This strap goes over the Bimini frame to help add some additional tightness / tension to the play pen cover.   The play pen cover goes to my...

Can anyone recommend fishing rod holders that clamp onto the top railings of a Benny?  Looking for rod holders to do some trolling. 

SpoiledRotten,   my outboard is a Mercury, not a Yamaha.  not sure if the little plastic cover is there or not.  I will check it out tomorrow when I get to he boat.

just wanted to check in and see if Rattletrap or anyone else can confirm if the nut the arrow is pointing too in the picture above is the right one.... best, Roo Raft

Is this the nut you speak of that would need some slight tightening??

Any recommendations on wax brands and types for the outboard motor cowls and my Benny's outside walls?