Recent content by Rssuttle

Need help. I have a 2021 21SX with 115 Yamaha can someone tell me what group size battery that would have been standard came with it. Say 24 or 27 Dirty to ask but.battery died and I forgot to check when I left. Thanks

I’m wanting to add an aluminum loading ramp ? If I do this I’m told the hook underneath for towing has to be moved. Can someone show me or explain where you remount the hook ? I tow all the time. Also a recommendation on a ramp that’s longer than 6’. If someone has installed one and could...

This might help find the correct size needing. Scroll through the pictures and you’ll see one of them has a diagram of each one they sell. Good luck...

That’s looks great. I’m sure this will help others looking ??

Sorry that’s happened. I hope that’s the only place they got to. Probably difficult to know what creature did this. Most will tell you there’s not much you can do but others have tried dryer sheets spread all around the inside or lots moth balls. Cleaning the inside after every trip and wiping...

I look at my fuel and trim level. I want to be able to set the instruments to alert me if I have an issue like temp, volts or oil pressure etc.. a little early warning. I’d like to see how the backbone is mounted and what was used to mount it so I can keep neat. If you have that could you...

Hopefully someone has an NMEA 2000 backbone installed by a dealer or professional installer that will share pictures of installation so I can set mine up the same. Where it was mounted and the mounting brackets , tools and hardware. Maybe you’ve posted them already ??? Do you like use it mucv...

Hey. Congrats on your new Bennington. Here’s what I think you should do. Call Andy at Sim Yamaha or email him at [email protected]. You’ll need to know your rpm’s at wot. Also which prop that’s on it now. Dia and pitch and model Power-tech. I just went through something similar...

Hey. I found them on eBay. I like them but I’m gonna change my holders to 15* angel or 30* degree. They’re a little to high up from what i’d like. Once I do that it’ll be a good set up. I bought a set off Amazon to see if i’d like them but Amazon price was a lot higher. So I bought them from...

Thanks for the help

I started off wanting to do a diy setup. But I’m only fishing two lines with rigs and I’m gonna go with just one single one out the back. I think it’ll work fine.

Advice please. I have a 2021 21’ SX with fishing chairs in rear. My factory livewell in rear with two flush mount rod holders that are 0 degree straight up. I think i’d like to change them to either put 15* or 30* or should I just keep them like they are ?? I have a rod holder on each...

Thanks for the ideas. I found one I believe will work. I bought two of them for under $45 each. I hope they’ll work. I only troll two rods at a time Thanks

Yep. I was hoping someone came up with it already and give some pointers. Thanks for trying to help. Now gotta find pipes that are light and strong enough

Thank you. This would be nice if I had the holes to set them in on each of the outside of pontoon. Look at the picture attached. You’ll see the live well has two holes you put rod into. I need a way to put it into those holes and bar that will reach to the outside of each side. The 2nd picture...