Search results

  1. B

    Sub and amp

    I don't have any rattling issues either but a buddy with the same boat, 2 years newer, the doorway rattles on his.
  2. B

    YOUR pontoon ideas!

    I replace two on mine already. I asked the dealer about the snaps and she laughed and gave me a handful for free. Said they break all the time. I little tricky to get the new ones in but I have a friend that let me borrow his snap tool.
  3. B

    Stereo upgrade options - after the fact

    I added a JL 4 Channel amp and a WetSounds Stealth AS-10 with enclosure with built in amp. Used existing Kicker speakers. Amp really woke them up.
  4. B

    Filling gas

    I think I will try this. I have checked every hose and there is no sag. I’m tired of dealing with this and gasoline spilling everywhere.
  5. B

    Sub and amp

    Under the helm and sounds really good. I assume you have an enclosure?
  6. B

    Sub and amp

    I just added a Wet sounds Stealth AS-10 with built-in amp. I ran the rear RCA's to the sub. You need to connect them to a 3.5 mm TRS female to dual RCA. This is on a 2016 with Sony DSX-M50BT. blue/white wire is REM out to turn the sub on.
  7. B

    radio memory

    that worked. Thank’s for the help!
  8. B

    Best way to clean and polish pontoon logs?

    Problem is that you have to remove that if your polishing the entire toon. Over the years the upper side got scummy for us. I’m sure the type of water you are in makes a big difference.
  9. B

    Best way to clean and polish pontoon logs?

    Do not use Sharkhide if your leaving it in the water, only if you trailer or put on a lift. It will get just as bad in the water and that much harder to clean at the end of the year.
  10. B

    radio memory

    Thank you, yes I did run a wire direct to the battery for the Yelllow (fused), but I did not run a direct to the battery for the ground. I will try that. During the summer we will boat at least 3 days a week so I dont see where a dead battery could be a high risk. I still have the other...
  11. B

    radio memory

    I have read all the memory wire forum discussions but I havent seen an answer for my situation. I have a 2013 SPDX S series. The Sony radio has a yellow constant 12v and a red accessory 12v that come out of the radio and then go in the same slot on the connector to the harness. I ran a wire...
  12. B

    Cleaning toons!!

    Love that shine!
  13. B

    Cleaning toons!!

    If you search the internet for the kit there are 2. One is an 8” and the one I selected is 10”. They are both the same but I went with the larger one. Smaller one will get into tighter spaces. Each kit has 3 wheels. Cutting, Seondary and finishing wheel and three rouge bars to apply to the...
  14. B

    Cleaning toons!!

    I won’t do the sharkhide again. the kit comes with a metal polish/protectant that I will use to keep them looking good. Sharrkhide is really only good if you trailer your boat or leave it on a lift.
  15. B

    Cleaning toons!!

    I used the Zepher Super shine polishing kit, I also bought an arbor extension for my 7” angle polisher.
  16. B

    Cleaning toons!!

    I finally bit the bullet and polished my toons. A lot of work but turned out great! Taking the sharkhide protector off was a real pain and I would never put it on again. You can see the difference in the second picture.
  17. B

    1st Oil Change

    I bought the "kit:" from my dealer. Box comes with 5 qts Yamalube, oil filter and new washer for drain plug.  I think it was $50.
  18. B

    Tables

    I eneded up using Gorilla construction adhesive and appears to have worked.  None of the original glue adhered to the top portion.  I was able to scrap all the residual with my fingers.
  19. B

    Tables

    I am having the same issue. What was the glue that everyone found effective? 
  20. B

    LED sidelights wiring?

    Here they are on the water 
Top