Fasttr
Well-Known Member
I wanted to place the name on the back of my boat but there is this beautiful Bennington logo there that I didn't want to remove and I thought it would have looked too crowded if I tried to add a stencil above or below. So my brother-in-law had purchased one of these signs for his patio and I thought this smaller version might look good on the back of the boat. I bought some 1" aluminum stock from Home Depot, cut it to length and bent the ends and attached them between the rails with some stainless hardware. I then used stainless hardware to bolt the sign to the new inserts. I placed it high enough to still allow the playpen cover to go over and snap to protect the sign and the sign is printed on both sides so you can see it from the inside or outside. We'll see how long it lasts but the supplier says it's intended for outdoor use...
My Install Picture
Link to eBay seller
My Install Picture
Link to eBay seller
Last edited by a moderator: