Pontoon Gauge Thickness

[MrG]

Hey I have some small dents that I'm gonna get pulled, The guy is using a Capacitor Discharge Stud gun. This spot welds a small pulling stud on to the dent where you can pull from. The tech was asking how thick the Aluminum is on the toons. I have a 2012 2575 QCW. When I was looking threw the "Build a Boat" section all I could find was a spot where they mentioned .100 Gauge Aluminum, Just wondering does this Aluminum Thickness apply to ALL Benningtons? I would think that a Twin Motor Monster Bennington would have a thicker Aluminum pontoon then lets say a 16 foot fishing pontoon.

Thank You

 

[1trotter]

Most are .100 , the I/O is .125

 

[MrG]

Ok that helps. Thank You.
Where did you happen to see/find this information

 

[Maholli]

Actually most r .80 and sps + and above r .100 or greater thruout, I believe the nose cones r .100 on all but its an option for .100 and above, atleast in 2018 it was. Actually i found out it is in fact .80 on all models below SPS + and nose cones r .100

 

[Maholli]

from website..