Currently my Trim Motor Gage only operates between 3/4 and fully down. (E-tec 90HP)
Motor trims up fine but gage stops in the 3/4 down position.
Any suggested starting point for troubleshooting ? )
Tilt your engine completely up and look for a stuck plastic lever in the upper left corner that is spring loaded. Spray with silicone spray to displace water , salt, debris. Work it with your finger or screwdriver to loosen it up. Please use caution in that tight space. Good Luck ️️
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.