yamaha not peeing

TroyBoy30

Well-Known Member
Messages
71
Reaction score
63
so this weekend i went to take the boat out. during motor warm up, i noticed the yamaha 175 wasn't peeing. It ran for about 3-4 minutes before I noticed. I shut it off and checked it out. found the hole was blocked with mud. not thinking i cleared the hole toward the motor instead of away from it. It obviously still didn't pee at that point. I packed the boat back up and went back later in the afternoon with better tools. i was able to use a long zip tie to get farther into the hoses and a section of muddy water and stuff finally came out. she's peeing fine now. the question is...i don't remember what the flow was like before. can i assume since it's peeing everything is fine now?
 
If you didn’t get an alarm and your getting a good stream in higher rpm’s you’re probably good to go.
 
Use compressed air and blow back though the pisser hole. This will not harm anything.
Sorry mods. Just using as simple of a description as possible!
 
Back
Top