I winterize on my own. Add Fuel Stabilizer to last tank of fuel, run Evinrude winterization routine after on trailer at ramp. I change water separating fuel filter and change lower unit lube. Pull prop and verify no fishing line around prop shaft seal. Vacuum boat remove anything that...
We have the Mid-America Tri-toon trailer for our boat. Swing away tongue shortens the space it takes up, Great ladder with handrail to access front of toon. Purchased new with our boat in 2020 at River Valley Marine Red Wing, MN.
I used a couple scrap pieces of lexan to suspend the Yeti from the fender clips with tie-wraps. Sits below top of rail and no velcro stuck to side panel.
We purchased our first "new to us" boat in 1991. A 1986 Sea-Sprite 23' Cuddy w/230 HP Mercruiser MR. We were lucky enough to find a slip on the Mississippi River near mile marker 813 since it didn't come with a trailer. Our neighbors had more experience on the river and knew how to go through...
Might be a little late but here is what I purchased, Still need to install. Front gate needs a 1" spacer to get past edge of seat. Will install 1/8" plate for side gate vs magnet on side of front lounge and SS screws with acorn nuts to hold to gate frames. Wish there was a way to replace...
This is genius! Definately copying after it warms up enough to remove the Shrink Wrap. Not a fan of Sharkhide either. My boat came with it from factory in 2020 and sits in the Mississippi River from May to October. cleaned the tunes every time we went out which was a lot since retiring in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.