Recent content by Harleymike

Putting a minn kota electric motor on the bow. But unsure which one. Do you guys think a 80 pound thrust is big enough.  I have the 24' dinette model. About 3000 pounds. Then calculations at mine kota say 80 is enough for up to 4000 pound boats. Mike

Was swimming around the boat today and noticed under the bow, where the wires go up through the floor for the navigation lights. There was another spare plug that wasn't in use. One on each side. Anyone know what this might be for.  Mike

I have the dinette model. My table separated also. After a month of use. I re-glued it with silicon. They are ordering a new table for me.  The stuff the factory used looked white. Was this the same colour as yours.  Im hoping the new table doesn't come apart also. If it does, I will do...

This isn't the small table on the stand. This is the big heavy table on my model. It has four seats around it. Its a permanent table on 2 legs. Sorry for the confusion. 

Its the main, large table. The top part separated from the bottom wood frame. The glue didn't hold. They are replacing it. Hope it ends with this. 

Boat doesn't even have 20 hours on it. We have the 24 dinette. Today out for a ride, some small waves, and the table top came off. They are just glued down and the glue let go. Anyone else had this problem. Kinda disappointed, I bought Bennington thinking I was buying one of the best.  They...

just what comes with the express package

express and 6 up front.

Went out today. Have 24 foot spdx with 150 hp. I can get 37 mph at 5800 rpm. I was surprised with 8 people on board and our gear I couldn't get over 23 mph. At WOT it wouldn't get past 5000 rpms. New to the pontoon thing and assume this is normal. But should i be careful how i run the motor with...

OK, 303 it is. I did read that But have always used meaguirs.

I'll try the 303. Thanks. I was going to put a coat of wax on the fiberglass stuff. Mine has the plastic bases. What is best for them. 

Hello just brought a new 24sldx. Love it so far. I have always used meaguirs marine vying and rubber cleaner /protectant. Is this ok for my new seats and won't void the warranty.  Thanks mike