I’m curious about changing out my 3 blade prop to a 4 blade. Size is a 15.25x 15. I would like to hear opinions if it was worth the swap and what size 4 blade should I be looking for. I was told I would have better maneuvering in the slip. It’s a Honda 135.
Thanks in advance.
You'll need to splice the wires, or that's what I ran into. The part fits perfectly, but the wiring connectors would not fit through the holes. I had to splice the wires to get them to go through.
No problem Bama. We used an electrician's tape and taped the cable connection end to the tape. Pushed it through one of the channels between the pontoon and floor (from the back towards the front). We were on the port side (mount is on that side for the transducer). Pushed it up to about even...
I did finally get the transducer cable ran. Used electrician's snake (fish tape). Had to tape connector end of cable to snake, push from the rear through channel, use a coat hanger to fish the cable out the left side. Then unhook cable, push snake from starboard side between floors to the...
I'm also replacing my depth finder for a newer one. I have a 2005 tritoon. How can I run the transducer cable? I had thought about just taping it to the old wire and pulling it through. I can't see the hole where the cable goes between the sub floor. Not sure if the connection plug will...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.