Dimensions for Lift set up

[supra1970]

Hi I was wondering where I could find the dimensions of the pontoons so I can set up my lift.
Boat's in storage and I'd like to get it set up prior to the lake water rising
Looking for width of the outside of the tunes (8.5' I think)
width of tunnel between the tunes,
Diameter of the tunes
height from the bottom of the tunes to the underside of the deck
width of the center motor tunnel and where it is under the deck

 

[Bill N]

https://club.benningtonmarine.com/attachments/bennington-pontoon-spacing-including-bowrider-pdf.35450/

 

[Vikingstaff]

https://club.benningtonmarine.com/attachments/bennington-pontoon-spacing-including-bowrider-pdf.35450/

Created a post and stickied it with this document in the “Technical Stuff” forum. Thanks for sharing it Bill. This will be a good resource for people. Do you happen to have a similar diagram for the other hull configurations we could get up on the forum?

 

[Bill N]

Created a post and stickied it with this document in the “Technical Stuff” forum. Thanks for sharing it Bill. This will be a good resource for people. Do you happen to have a similar diagram for the other hull configurations we could get up on the forum?

That has every 3 tube configuration.

 

[supra1970]

That has every 3 tube configuration.

I contacted Bennington customer service they sent me very detailed drawings of the underside and topside very helpful

 

[Vikingstaff]

That has every 3 tube configuration.

Sorry, I meant the traditional 2 tube hulls and EPT and Elliptical hull configuration. Any chance you have access to the same type of diagram for those? If not, no worries.

 

[Bill N]

Sorry, I meant the traditional 2 tube hulls and EPT and Elliptical hull configuration. Any chance you have access to the same type of diagram for those? If not, no worries.

https://club.benningtonmarine.com/attachments/tube-support-spacing-3-13-pdf.493/