Recent content by BobbyZ

Do you notice any prop blow out or cavitation? How far are u able to trim before ventilation? Cornering tight without blowout? You have a Yamaha reliance prop?

Thanks for the info. Def gonna try next hole. I was looking at it today and motor shoots a little roost even when trimmed. I think one hole will get me best set up. I'll try that then dial in the prop later.

I'm running non ethanol 91. Taking it out again today so we will have to see.

Gotcha. My dealer is gonna move the motor up a hole for 30 min labor. I think that will put me where I need to be. Thx man

I'm gonna move mine into 2nd hole as well . I think hole 1 makes it sit too low in water creating more drag. Ur specs are inline with others that are in hole 2. What rpm do u pull with light load 1 or 2 ppl and what do u pull loaded when ur hitting mid to upper 30's?

Looks like ur in 2nd hole from top

I have same exact boat motor and prop. What mounting hole are u in on engine? Top hole or next one down?

What is ur RCW set up. Twin or triple tube? Just u on board?

I have a 2018 23SSBXP with a 175 Yamaha SHO. Would like to be as close to 6000 rpm as possible with light load. All around performance. Like 40 mph or better. Thx Rob

This is first year for me. Just picked it up used from original owner. I drove a 22 footer with same motor and prop. Im getting speed from my Garmin GPS trimmed at 3/4. What prop are u running? Im gonna prob be switching to an aluminum just because of the rocks. Did u see any rpm increase...

What holes are ur motors mounted on as far as height. Top hole or 1 or 2 down?

I have 50 hours on the motor

Complete underskinning pontoons are spotless, I don't keep in water