mtudb24's latest activity
-
mtudb24 replied to the thread WOT going straight to 7k.I assume you have a 115hp 4 stroke? Its not a 2 stroke is it? They still made the optimax DFI back in those years. Reason why i ask... -
Fuel Tank Vent .I have it on mine
-
I had an issue with my Yamaha not tilting all the way down. The trim rams need occasional lubrication and there are two bolts that...
-
The trim gage system consists of two parts. The gage on the boat dash and the tilt sensor on the motor. The tilt sensor is most...
-
If the issue is part of the motor and you do not have an extended warranty it may not be covered under warranty.
-
Welcome to the forum Losman. Next time you go out while sitting at the ramp or dock trim your motor up/down to several heights/levels...
-
You're Welcome.
-
Starting with the 2025 model year, Bennington started using Metal Jacket instead of sharkhide. If you ordered the boat it would have...
-
Figured it out! Found a semi-hidden fuse on the engine that was very blown.
-
The kill switch should be next to the ignition switch. Check the master power switch too .
-
Bump Up ,7/25/25 . Please read post 1 & 2
-
The terms of service to which you agreed to follow when you joined this site are a little hard to find again after the fact. Here's the...
-
A fresh post on “acceptable” posts is in order. Short and sweet. This forum has zero tolerance for political discussion, debate, memes...
-
mtudb24 replied to the thread Opinion on Prop for my 2025 24LXXSB.That's good to know. You have real world data that we aren't privy to. We can only go by the data we are given and from the graphs...
-
mtudb24 reacted to Potomacbassin’'s post in the thread Opinion on Prop for my 2025 24LXXSB with
Like.
Out of curiosity did you have to sign an NDA? Rumor for a while was you could get a refund but only after agreeing to some paperwork...