Recent content by Seadoorxpguy

ill double check how i wired them when i get down to the boat this weekend and i am running two Polk Audio PA D5000.5

After all the issues I had with my 3500 ram that got bought back I just rent a truck from enterprise commercial the few times a year I need it now

Bennington factory installed amps usually have tamper proof tape over the adjustment knobs. It could also be a setting in the head unit. Very hard to diag radio issues without seeing how its wired and what settings are selected in the head unit

Probably does not have a sender connected to it. Can you go into the settings and see what's connected to it?

time for a water pump or possibly a clogged passage.

Thats the Mb quart na4 400.1 power connection?

So if you plan on being at the sandbar with the engine off you should make sure to have you're battery switch set to only one battery. The battery specs will determine runtime of the radio. What are you putting wire nuts on? The cable size doesnt matter on how difficult the run is. The first...

Order a blue seas acr. Easy to install then no more potential for dead battery

How is the boat wired? House off one battery motor off the other? A acr is a charging relay. i installed a blue seas one in my boat. Keeps the motor battery seperate so the boat will always start then it charges the house battery after the starter battery is fully charged

Add another battery and a acr or you will find yourself looking for a jump pack

I powered mine off that same fuse block. Just ordered the right fuse for the new amp

i tried the guides, hated them. I end up trying to get the trailer as close to the dock as possible. Then i slide the bow on and strap it. Ive trained the wife or a few friends how to line up the rear with the trailer tail light as I pull forward slowly.

Where is you're battery compared to where the amp is? 6 gauge looks to be too small if your running 20 ft

You dont need a amp with rca in and out. You can run a rca splitter like I did. For a amp that size Id probably run a thicker gauge and if youre mounting it under the helm id go 25ft. Easier to cut it shorter than pull it though and be a few feet short

I ended up marking the holes out. Taking the seat back off, drilling holes. Then installed long 4" stainless bolts that faced into the storage compartment. then stacked my amps.