Recent content by tothetrail

Ya, good question. I can't look at the boat now as it's in Arizona and I'm in California, but yes, I don't think there is much room. I always dry that area when I get home from a trip, so I'm able to get a towel down there and sop up the last inch or so of water, but I don't see how you would...

See this post, lots of good suggestions. https://club.benningtonmarine.com/threads/auxiliary-fuel-tank.12557/#post-173965 Mine is post #15. We got two more caddies for last trip, so five total. ,

I'm not sure. The only time I ran them was after a big wave at Lake Powell that put water in the center storage. Since we were in the water, I couldn't tell. Next time I'm under the boat I'll see if I can tell where the tubing is routed.

On my 2015 2575 RSD, there are two. One is in the back, under the fuel tank. I think it is accessed from the rear flip-up upholstered bench top, where the engine batteries are located. The second is as described above, under the composite board in the center toon storage.

Or maybe see if they would be willing to just give you the amount it would cost in materials and labor, and you can do it yourself or find a shop of your choosing?

I did the same, removed the whole thing and covered the hole. Much better use of the space when it is removed.

Not sure how much room you have, but this looks pretty cool. https://www.nauticaldesigninc.com/images-2022April/CustomConsole-Livewell-20211231_113511.html

I'm pretty sure you can go through a dealer for decals. As for the bimini struts, those can also be ordered through the dealer. But I've seen people offering those pieces that came off a broken bimini frame. If your attachment parts on the ends of the struts are still good, and you have a...

When I had a big wave come over the bow at Lake Powell, it put about 3" or 4" of water in the center toon storage. We hit the bilge pump switch and it pumped out all but about an inch of water at the rear of the storage compartment. It took a while, but was able to eventually dry out it out...

Also wondering if anyone has attempted to fabricate fiberglass storage "containers" on the front deck, like they have in the Q boats in the front, similar to these, but with the opening on the other side. I'd like to come up with something that would fit the Honda EU2200i on a slider, that...

I have a 2015 with the same motor and had the same issue. We were eating on the boat and all of a sudden, the motor was moving up. Hit the switch and it stopped. Then when it did it again just shut off both batteries to make sure it wouldn't move again. Since neither the trim switch on the...

Not sure what lake you are in, but on the Colorado River lakes, the water is super hard. The groundwater is really bad, so not sure if the river/lake water is similar, but trying to use misters on a home, even with treated water is really tricky. Unless you get the super high PSI pumps, the...

Thank you, exactly what I needed!

Did you ever get long horizontal guides installed? I'm still trying to decide between the horizontal or the vertical. Is this the horizontal guide type you were looking at? https://pontoonloader.com/

Possibly, but I'm wanting a thin terry cloth/towel material for it. Any vehicle covers seem to be thick vinyl or other bulky material. But thanks for mentioning it, now I'm going to look a little better.