Hello there. I'm looking at a Bennington Saltwater 23SFBCXP 23' tritoon. My first run at a tritoon type boat and have to restructure my lift from a V hull type to a tube type boat. Question; do I need three bunks to equalize the weight on each tube or just the two outer tubes. Also I'd like the build list for this particular toon and the seller doesn't know much about the specifications. Where can I get a copy, if they publish those. I have an email request in to Bennington but so far no response. thx
bunk placement on a tritoon
- Thread starter Joe Camel
- Start date
Jack M
Moderator
Here is the phone number for Bennington 888 906 2628. Have your Hull ID if you call .
You may get mixed opinions but I would add a center bunk , your motor is hanging off that center toon . Also did you transfer the balance of your warranty at an authorized Bennington dealer?
You may get mixed opinions but I would add a center bunk , your motor is hanging off that center toon . Also did you transfer the balance of your warranty at an authorized Bennington dealer?
DVW
Well-Known Member
- Messages
- 366
- Reaction score
- 645
Do not know what you mean by a ‘build list’. I doubt Bennington would understand that term. A parts list would be proprietary information. Pontoon boats are primarily 102” wide. Bunk centerline spacing required is simply the width of the boat (102”) minus the width of one outside tube. Bennington has two tube shapes. The round tube is 25” wide (diameter) and the fat tube is 32” wide. Hope this helps.
Last edited: