Dinette Table Disassembly

[sthomas3rd]

I have a 2016 G22 delivered on September of 2015. Despite its ten year exposure to the upper Chesapeake bay, the boat is in great shape. I keep it covered when not is use so it gets little UV damage. I have it shrink wrapped for the winter.

Well, that time is here and I need to repair the dinette table before winterization or remove it to repair during its storage. The table is lifting on the end near the center of the boat. I don't see any fasteners so I'm assuming it's either, glued or screwed from the column shroud. It has the pretty blue lights so I know there is wiring involved as well.

Does anyone have experience and/or instructions for the table disassembly?

Has anyone made this particular repair?

Thank you.

 

[sthomas3rd]

It's been about a month and a half since I winterized the boat. I did attempt the disassembly to find only a small opening for the wires that power the lights. With the constraints of time, I reassembled the table and winterized the boat.

I'll attempt again in the spring but I'm thinking I'll just push glue in there the best I can and clamp the table until it dries. I'm really glad the light are OK because any maintenance required inside the table/shroud would require delaminating the table.

 

[Jack M]

I dont have any suggestions,but if you have a picture of the table that could help others who may have an idea .