Matthewstm
Active Member
- Messages
- 29
- Reaction score
- 3
Do they make a flag pole that fits in the ski pool holder on the back of the Bennington?
Flag Pole
- Thread starter Matthewstm
- Start date
Vikingstaff
Moderator
By ski pole holder, do you mean the pylon receptacle that some boats have vs. a tow bar or turbo swing…? If so, I don’t believe so. However, you could probably DYI a flag onto a ski pylon when not tubing/skiing, if that is what your set up has.
They do make a lot of boat flag pole options, and of course you can always add on Bennington’s OEM after the fact by ordering one. Do some searchers as well in this forum in the upper right hand corner search box. I know there have been some posts over the years with people rigging up flags in different ways themselves.
Seadoorxpguy
Well-Known Member
- Messages
- 137
- Reaction score
- 182
I ended up taking my pylon out and finding a few different sized pvc fittings from home depot that fit in there good.
dshannon11
Well-Known Member
- Messages
- 135
- Reaction score
- 164
I used to run harbor freight pole in the ski pylon hole. Used to move around a bit. Now I use 2 “endless” tie downs to strap it to the pylon.
Works perfectly at 35-40mph…
Going to have my buddy weld 2- 2.5” aluminum pipes that are about 2’ long parallel together. One will slide over the pylon, the harbor freight pole can slide into the second. This will look cleaner than the tie downs. I’ll take a pic of the set up tomorrow if ya want.
dshannon11
Well-Known Member
- Messages
- 135
- Reaction score
- 164
I use 2 ratchet straps. Tested it this weekend with great results. I’ll trim and burn ends shorter next time I’m at the lake.
That's exactly where I want to mount a flag pole. Do you have a drawing on it? How did you mount the plate to the bar?
Jack M
Moderator
The post over a year old , poster you quoted hasn't been active since last September. You can send him a PM .