I'm sure this is discussed before, but on my 2015 QCW I have a electric anchor winch and also my ladder both are which somewhat loose and could stand a little tightening up from the underside. Both are covered with solid aluminum panning. What does everybody do to access these bolts to tighten or in the case of the anchormate, remove it and replace it if it's faulty. Want to do this once the right way, before I screw anything up.
How to access covered underbelly bolts?
- Thread starter stbentoak
- Start date
I'm not familiar with your specific model, but I assume your anchor and ladder are up front? If so and if it was like my old 2011 RCW, my wave shield / wave tammer was riveted in and you'll have to drill them out to gain access to the bolts of your ladder and anchormate. Then replace the rivets.