Need fishing electronics advice...

[cav2588]

Hello all!

I have a 20SSXSST (2022) and looking for ideas on how to mount multiple graphs.

Putting trolling motor on starboard bow corner (right front corner for landlubbers).
Separate LiveScope pole will go on port bow corner (front left).

Deck in front of gate is roughly 22" wide (my preferred fishing location).

I'm trying to figure out where to mount display for both LiveScope and a 12" EchoMap display.
Goal is to minimize clutter in front of gate.

Initial thought was dual mount side by side in front of console with ability to swivel 180 degrees.

Attached picture of layout.

Thanks in advance for your help!

MP

 

[Potomacbassin’]

Yikes, tricky given the tight space up front.

I would just mount the LVS transducer to the trolling motor like most bass set ups and mount a graph on the floor port side. Your neck is going to be cramping by the end of the day though given you'll be looking almost directly down and to your left while you scope.

I had my deck and furniture layout customize built for this exact reason, given I use my boat almost exclusively for fishing. 41.5" of bow deck space. Haven't pulled the trigger on a TM yet but scoping would still be tough to figure out.