Back to the main site

Ishoot308's latest activity

  • I
    Ishoot308 replied to the thread Motor Well Covers.
    One thing I didn’t think about when installing these covers is the snaps for the mooring cover. A couple of them are in fact underneath...
  • I
    Ishoot308 replied to the thread Motor Well Covers.
    On the narrow beam models with twin engines, there is very limited space to board back there without them. I have no port side boarding...
  • I
    Ishoot308 replied to the thread Motor Well Covers.
    Here’s a pic of the underside showing the foam tape application and the dock bumper rubber piece I used…
    • IMG_6689.jpeg
  • I
    Ishoot308 replied to the thread New Boat Home!.
    Congrats! Looks great! Dan
  • I
    Ishoot308 replied to the thread Motor Well Covers.
    Yes no problem!
  • I
    Ishoot308 replied to the thread Motor Well Covers.
    No they can’t bounce out. I removed one of the trim screws and extended it through the cover so it’s held down can’t go anywhere. By...
  • I
    Ishoot308 replied to the thread Motor Well Covers.
    Yes, the material I used is very strong and does not flex at all…
  • I
    Ishoot308 posted the thread Motor Well Covers in Pontoon Forum.
    I made these motor well covers for my new Benny Q-27X2. I made them so they can stay in place when running. They do not interfere with...
    • IMG_6692.jpeg
  • I
    Ishoot308 replied to the thread Correct Prop Questions,.
    I have not noticed any discernible difference when docking using a four blade over a three. Then again, I have not used my boat in...
  • I
    Ishoot308 replied to the thread Correct Prop Questions,.
    A four blade prop will give you a little more bite in the corners and slightly better hole shot but more than likely you MIGHT lose a...
  • I
    Ishoot308 replied to the thread Kicker Radio problem..
    It could be moisture inside the radio. Some radios have a built in sensor that detects moisture and will shut down or work...
  • I
    Ishoot308 reacted to Vikingstaff's post in the thread EZ Fender Question with Like Like.
    Not Dan, but here is what he is referencing. You can check with an authorized Bennington dealer about them:
  • I
    Ishoot308 replied to the thread EZ Fender Question.
    Here’s a quick YouTube of what they look like and how they work…As you can see in the video it is a very low profile button that gets...
  • I
    Ishoot308 replied to the thread EZ Fender Question.
    Curious why you didn’t get Benningtons “Quick Fender Latch Kit”…it’s a lot less intrusive than the EZ Fender…. Dan
  • I
    Ishoot308 replied to the thread Where to put a Yeti cup.
    The best deal on stainless tumblers was a few years back when “Members Mark”/ Sam’s Club was selling the 30 ounce tumblers two for...
Show older items
Back
Top