Recent content by rgrayiam

As mentioned before, mine was close to expected arrival time. Dealer hooked up all of my add ons and when they attempted to take it out for a test run, the Sea Star power steering didn't work. They worked with Bennington and believed the pump was bad. A week later a new pump came in. Put the...

Anyone use solar panels to fully charge a 24v deep cycle trolling motor system(2 twelve volt batteries)? Trying to leave our boat at the marina, but there is no power. In order to avoid hauling it from home to ramp all the time, was wondering about solar panels. Just wondering if anyone is...

We ordered our 23SXFAPG fishing boat on 23 June and made a few changes on our end over the next few days. We were told production would start the week of 14 August. Work started on 17 August and delivered to our dealer on 8 September. Our dealer said it normally takes a little under 2 weeks...

I ordered the SX 23 fishing model over the L model. Cheaper price and in my mind wasn't worth the price difference. As noted above, the SPS+ toon package is better and can handle the 250HP. I went with the 250 for increased HP and the V6 engine since it gets better fuel economy than a 4...

I ordered my new 2024 boat 6/23/2023 and was told production was supposed to be the week of 14 August 2023. We shall see.

Thank you

Thank you and good point for the trolling motor which will be on my boat.

Thank you. Do you have any rod holders that you fish with? Again, those tall walls being the issue to mount onto. Thanks

I am having a 23 SXFAPG (fishing) tritoon built. Want to add a second GPS/depth finder since the Simrad on the dash is hard to see through the steering wheel. I was wondering where anyone may have mounted the second transducer since there isn't much space on the mount at the rear of the right...

Thanks. I am glad they do now.

My Bennington I just ordered is supposed to come with a ten year bow to stern warranty. Maybe that doesn't cover lights and maybe the 2014 models didn't come with that. I would ask. Otherwise a new assembly would most likely need to be replaced since you can't just replace that LED

Thanks. What kind of rod holders are you using with the Railmount star port? Was wondering if any brand like Scotty would work or do you have to use Railblaza? Wasn't sure if Railblaza had a proprietary star size or not. I am anxious to get the boat (end of Aug) and get fishing.

Was checking to see how these are holding up and working? I have read some reviews on these and the complaints were that it comes loose on the inside since the piece hanging down doesn't go down very far. Wouldn't use for trolling but was worried about bottom fishing for cats or stripers...