Transducer issue,need some advice!

Busstuf

Well-Known Member
Messages
47
Reaction score
65
Ran over some debris in the TN River causing me to break a Garmin transducer bracket. If I will need to replace, and my R23 with ESP has to come out of the water, I would consider changing out to a bigger unit. If I go that route,any ideas on a bracket available to cover the garmin there now and extend out so you are not restricted to a 5” graph In the recess shown.
 

Attachments

  • D03BE4DE-224B-4D20-AF89-CC8E620152E9.jpeg
    D03BE4DE-224B-4D20-AF89-CC8E620152E9.jpeg
    56.4 KB · Views: 29
  • D0FCD6CC-9BBB-4DD3-87E4-074C96B854F2.jpeg
    D0FCD6CC-9BBB-4DD3-87E4-074C96B854F2.jpeg
    74.2 KB · Views: 29
  • 34720651-8AAF-4BEB-9B4F-D052210B3D11.jpeg
    34720651-8AAF-4BEB-9B4F-D052210B3D11.jpeg
    45.8 KB · Views: 29
Last edited:
I changed mine on my 2014 RCW , to a 53DV Chirp. I contacted Gamin prior to my purchase and they emailed me a templet for the 53 .
Minimal cutting was required .
You can contact Gamin with the link below or call . They were Always helpful when I called them

913-397-0872 ,1-800-800-1020
 
I did Jack. They don’t make much in 5” anymore!
Did they have any suggestions ? They can email a templet for which ever model you think may fit .
 
I replaced the original Echo with this. It’s a 53 CV. There is a little bit more room there but I don’t think it’s enough for the 7” models. Like Jack suggested, get the template from Garmin and map it out.
 

Attachments

  • ABB157D6-D8FA-45D5-B7D6-D0EEC4E64D8A.jpeg
    ABB157D6-D8FA-45D5-B7D6-D0EEC4E64D8A.jpeg
    93.9 KB · Views: 10
Back
Top