These are pictures of the seat base on my 2010 Bennington 24 SLi. I sit pretty low in this seat. I'm 6' 3". Is this seat supposed to have adjustable height?
I don't think so, but there are a few levers on there.
If not adjustable, are there any reasonably priced ways to upgrade to an...
Me again. Getting closer to pulling the trigger on this. I'm getting the Garmin ECHOMAP UHD 63cv.
I am tempted to mount it smack dab in the middle of the dash! I know it will block the tach and make the fuel gauge and engine tilt gauge hard to see, but I'm not sure I care.
Thoughts?
See...
Can you tell me which RAM mount you used? That looks good!
This is where I want my mount to go. In front of the windshield, in the far right corner. Where my wallet is sitting in the picture (smart, right?). It will need to be maybe 6-8 inches tall, to have the unit clear the windshield...
I think I have this problem licked. Picked up a 2 pack of stainless steel "star" lock washers from Home Depot for 75 cents. I got 3/8", but I think 5/16" might work better. I used both of them. Seems to have solved the issue for under a buck.
I've got a 2010 24SLi and I am wanting to add a GPS/Sonar. I've been a Garmin user for a long time, so I am thinking of getting the ECHOMAP UHD 63cv. Maybe the 73cv. I want to surface mount it, not cut up the dash. Can I see some pictures of what others have done? I am thinking I might need...
Amazon rod holder works great! I adjusted the rod holder to be more vertical after I took the picture.
This is just a temporary cheap wooden flagpole from Lowes until my special rod holder flag pole comes in next week. I got this one in 4'...
Yes, it is a Perko. I just came back from the boat. Tried to put a split locking washer on it, no help at all. This is a dumb design. I cranked it pretty much as hard as I could, still easy to lay down by hand. I think I will make it "semi permanent" with some VHB tape, and shop for a new...
That is good info! I couldn't imagine how I was missing a piece. The base should have the opposing teeth. Dumb design I guess. I think I will take it apart and see if I can stick a big rubber washer or grommet on there for the teeth to grab onto, maybe that will help.
The other idea I got...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.