wiredup55
Well-Known Member
I have gone through the search on old threads regarding boat lifts, and haven't really found an answer to what I am looking for. I have a boat lift on a saltwater bay, not a lake, so a typical 4 piling 8000# boat lift. It is now set up for my chris craft I am selling, so for a v bottom boat. What mods have any of you done to that type of lift to accommodate your triple toon boat? The boat on order is a 2016 2575 RSB with ESP.
I have seem some people using cages, I would like to avoid those as I don't have a lot of water to lower into.
It seems like the easiest mod is to have 3 parallel 10-12' 2 x 10's with carpet on them, would that work?
Are all three tubes at the same draft? or is the center one lower, thus changing the modification?
Any info is appreciated!
I have seem some people using cages, I would like to avoid those as I don't have a lot of water to lower into.
It seems like the easiest mod is to have 3 parallel 10-12' 2 x 10's with carpet on them, would that work?
Are all three tubes at the same draft? or is the center one lower, thus changing the modification?
Any info is appreciated!
Last edited by a moderator: