I already have one HydroHoist lift for my Mastercraft. I am going to need another for the toon when it gets here in May/June. Question : Does anyone currently have a HH lift configured to fit the elliptical center toon? Pics would be great. I'm sure it can be done, just have not seen one yet.
I converted my 2000 Hydrohoist from a Cobalt V-Hull configuration to my Bennington Tri-Toon with ESP. I just have 3 sets of parallel carpet covered bunks and it works great. It is supporting a 250 hp Yamaha on the center toon as well. Fairly inexpensive retro by my hoist service people. Good luck and enjoy your new Benny!! I can get some pics next time I am out to the lake.
I converted my 2000 Hydrohoist from a Cobalt V-Hull configuration to my Bennington Tri-Toon with ESP. I just have 3 sets of parallel carpet covered bunks and it works great. It is supporting a 250 hp Yamaha on the center toon as well. Fairly inexpensive retro by my hoist service people. Good luck and enjoy your new Benny!! I can get some pics next time I am out to the lake.
Thanks Craig. I'm sure it is not too difficult but was just wondering what it looks like and what, if any, additional cost is for the extra bunks for the third toon. Have to believe its critical to support the engine weight properly.
Thanks Craig. I'm sure it is not too difficult but was just wondering what it looks like and what, if any, additional cost is for the extra bunks for the third toon. Have to believe its critical to support the engine weight properly.
If you have a V hull lift you can buy a tritoon conversion kit from hydrohoist, that's what I did for mine. I've also seen lots of lifts locally that have homemade setups and they seem to work fine also. If you're ordering a new lift you can get it already set up for the new toon. Scott Mauldin in Baxter TN is the main Hydrohoist distributor in the south east and he's a great guy to deal with. PM me if you need his number.
If you have a V hull lift you can buy a tritoon conversion kit from hydrohoist, that's what I did for mine. I've also seen lots of lifts locally that have homemade setups and they seem to work fine also. If you're ordering a new lift you can get it already set up for the new toon. Scott Mauldin in Baxter TN is the main Hydrohoist distributor in the south east and he's a great guy to deal with. PM me if you need his number.
