FIRE UP
Well-Known Member
- Messages
- 131
- Reaction score
- 252
Hey Gang,
Been bit since I posted. The last time I posted, I was installing a replacement Garmin GPS unit because the factory installed one, after about 8 years or so of flawless service, decided to stop tracking and showing charts, shoreline and more. It's a long story but in short, the Garmin support could do nothing to improve the situation. So, I purchased and installed a newer, more improved model. The new one works outstanding. However, I have a problem. I lost my speedo! It stopped working right after the install of the new GPS. There are, about a dozen wires in the harness for that GPS. But, the instructions say to only use the Red and black for obvious destination connections. Then, because the new GPS came with a new transducer, I installed it and ran the cable up to the new GPS unit.
The old GPS was wired with a red, black and brown that went to a white wire in the boats harness. I wired the new GPS in the same fashion, at least I think I did. I thought I'd hooked up all that was needed. But, apparently somethings amiss. I have no speedo.
Sooooo, what I'm asking for is a wiring diagram for a 2014 Bennington 25RCL with the Yamaha 5.3L 350HP. I'm pretty darn sure this speedo issue is GPS related.
Scott
Been bit since I posted. The last time I posted, I was installing a replacement Garmin GPS unit because the factory installed one, after about 8 years or so of flawless service, decided to stop tracking and showing charts, shoreline and more. It's a long story but in short, the Garmin support could do nothing to improve the situation. So, I purchased and installed a newer, more improved model. The new one works outstanding. However, I have a problem. I lost my speedo! It stopped working right after the install of the new GPS. There are, about a dozen wires in the harness for that GPS. But, the instructions say to only use the Red and black for obvious destination connections. Then, because the new GPS came with a new transducer, I installed it and ran the cable up to the new GPS unit.
The old GPS was wired with a red, black and brown that went to a white wire in the boats harness. I wired the new GPS in the same fashion, at least I think I did. I thought I'd hooked up all that was needed. But, apparently somethings amiss. I have no speedo.
Sooooo, what I'm asking for is a wiring diagram for a 2014 Bennington 25RCL with the Yamaha 5.3L 350HP. I'm pretty darn sure this speedo issue is GPS related.
Scott