youghpirate
Member
so this saturday we were out at the lake, swimming and i noticed something strange. i have a 2011 20' SLI. this is the basic model of Benny, 2 toons, fuel tank in the center under the deck in front of the motor in a wedge shaped aluminum housing. (please xcuse my descriptions as im not sure of the correct names of the components) as i was swimming past the back of the boat i looked under the deck. looking at the boat from the rear, on the left side there is an aluminum plate that covers the underside of the deck from the edge of the pontoon to the center "wedge shaped" compartment where the fuel tank is located in front of the outboard. it is about 4' long (guessing) and 2' wide at the back and tapers to about 3' wide at the front. im assuming this is a splashguard. but there is not one on the right side between the pontoon and the fuel tank compartment.
is this a factory mistake or is it supposed to be on one side only? you can see where the holes were drilled at the factory for the instalation but it was never on there. it is held on by 5 rivits. the holes dont even shows signs of rivits ever being installed in them.
is this plate supposed to be on here? the only reason i could think its on the left side and not the right is the left side is where the fuel filler hose comes in from the side of the boat.
any ideas or comments?
thanks....
is this a factory mistake or is it supposed to be on one side only? you can see where the holes were drilled at the factory for the instalation but it was never on there. it is held on by 5 rivits. the holes dont even shows signs of rivits ever being installed in them.
is this plate supposed to be on here? the only reason i could think its on the left side and not the right is the left side is where the fuel filler hose comes in from the side of the boat.
any ideas or comments?
thanks....