I had the same problem with my KMC10 after just 2 months. Head unit just died and would not turn on. I called my dealer and they swapped it out for me same day. Well see how long this one lasts. There is a new version of this head unit on the Bennington web site. KMC100. Has additional outputs.
I also have the wave shield on my swing back and running the wire from the front seat to the helm was easy. It runs along the back of the front seat and then into the helm compartment. Took me about 10 minutes to fish it through.
Just added another sub to the boat. I have the Rockford Fosgate 12 inch punch in the back seat and now added this 10 inch Kicker TB tube to the front. Fits great and sounds great. Install was easy with an amp located in the helm.
I did run 2 separate sets of speaker wires from the helm back to the back of the boat thinking that was how I was going to have to separate them. But the purple, purple black wires go to the right stern speaker and green, green black wires go to the left stern speaker. I guess I could add some...
Yep it doesn’t fully fade. I have the 4 interior speakers running off the front RCA’s and the 2 sterns off the rear RCA’s. The new KMC100 supposedly will fully fade but not the KMC10.
I also have the swingback layout with the stern speakers. I could not find the splice under the helm. But I did find out that the purple, purple black and green, green black are wired directly to the stern speakers. The white, white black are running to the left side interior speakers and the...
Just passed the 10 hour break in period.
Boat Model --------- 23 SSBXP
Model Year --------- 2019
Toon Package ------ SPS+
Motor --------------- Yamaha F250 mounted in lowest position, digital controls
Performance ------- WOT 46MPH GPS AT 5400RPM. 46 Gallons of gas, 4 adults, clean tubes, top...
I have a 2019 23ssbxp with the Yamaha F250 digital controls. Prop is the SWS II 15.5 17P. The motor is in the lowest hole. Just passed the 10 hour break in. I’m hitting 46mph WOT with a full tank of gas(46 gallons) and 4 adults onboard. My RPM is only at 5400 though.
I also have the KMC10 Head unit with Kicker lighted speakers. I didn’t go for the amp or sub upgrade since I was planning on doing that myself. In the process of setting up the amp I’m a little confused. I have the kmc10 wiring diagram but need the speaker wiring diagram after the head unit...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.