Recent content by jeffandpamsmith

I have a Tri toon either FS2575 (uncertain on the letters). 2001 boat and motor. Merc 125HP 2 stroke. Runs well, 5000 RPM at about 30 MPH tops with slightly dinged aluminum 3 blade 15" pitch. I want to get a stainless prop as I have lots of low water spots (mud and sand, no rocks), and the...

Yes I have searched, a lot. Read in posts a few years ago that the fence with the square aluminum rail had to be replaced with the panels and was only sold as one piece (including graphics). I cant afford the entire 60+ feet new. I have a 2001 model 2575FS that I bought used. It was a...

Thanks to all, I think the flat boards are the way I will go. I will have about 3' of toon hanging free off the back and 6' of toon off the bow as the boards are 16' 2x10s and I plan on running a 2x6 vertically below the middle of each board to limit flexibility (or is this overkill?). The...

Sorry for being a newby but I just noticed my model (2575 I think 2001), has lifting strakes and a "keel" running down the center of all 3 toons. It is about 3/4" tall and 1/2" wide. If I set the boat on flat boards it would rest only on the keels. Is this OK? Most toons are round, but I bet...

I just bought a used 26' tritoon and have tidal water that gets very shallow, so every inch counts. I have a boathouse with existing heavy duty lift, and can either run a 2x10x16' flat board with carpet under each toon, but that would leave a lot of bow hanging over. I am intrigued by the...