Recent content by truckone176

Thanks for the replies, I can't do the sea leg option as my lake fluctuates too much and have a slip to dock my boat. The drive-on dock floats look interesting as you don't need power, just can't get any firsthand information on them.

I was wondering if anyone had any experiences with the drive on boat slips lick the brands Jet Dort or EZ Dock? If you do, what are your thoughts or experiences with them, do they last a long time, do they wear the toons? The reason I ask is that my slip isn't deep enough for a traditional front...

Three of my speakers are in the seat bottoms and those are the ones that I'm wanting to make sure will fit. I know I have to trim the area, just want to make sure there is enough room in the base before I order.

I have a 2013 2275 RCW with the factory 6.5 inch Kicker speakers. The boat is in storage right now, but was wondering if anyone knows if the 7.7 JL speakers will fit with some trimming? Has anyone done this before?

My slip at my dock is too shallow for a lift style boat lift, but I was wondering if anyone has an insight on drive on docks. The style I'm thinking of is Jetdock or Dock Blocks. They are floating docks that you drive up on, like the type you see for PWCs.

I’m in your position, sort of. I have a 2013 model with the analog gauges and would love something that has the oil pressure and temp also.

I have a 2275 RCW tritoon, my question to everyone is how do you get to the bottom of the 'toons to clean the gunk off. How do you lift the boat while on the trailer?

Hey guys, I have a 2013 2275 RCW with a Yamaha 250 SHO. My question is this, i don't have anything other than fuel, trim, volt, and RPM gauges. Does anyone else have other gauges like temp and oil pressure?

Thanks, like to hear about the difference.

Yes, my motor is as low as it can go but was wondering if anyone else has tried moving it up a hole or two.

Hello, I have a 2275 RCW with the Yamaha 250 SHO. I noticed this past weekend the the motor is mounted on the upper most hole. I was wondering where everyone else has their motor mounted?

Ok thanks, I will check with my dealership.

How long is the warranty on the covers for our boats? I have a 2013 2275 RCW and there are two spots where the cover is deteriorating and starting to pull apart.

Hey thanks for the replies, that’s what this place is for.

i have a 2013 Yamaha 250 SHO and still have some confusion on fuel octane requirements. The lake that I boat on has straight gasoline available but it is a few octane points lower that needed. However, I can get the gasoline with ethanol at the higher octane rating. What does Yamaha say do or...