Dan S
Well-Known Member
I received delivery of my 21SX Bennington early May of 2015. Burgandy mooring cover with snaps. It appears I’m having major failure of the material. First there was a small stretchy looking hole behind the helm seat and I just wrote it off to a stick falling from a nearbky tree. Then there was a fairly good size ‘pulling apart’ tear near but not at the center post support itself and I could’nt figure it out and got a patch sewed on. Today, two days later after some heavy rain 1”+, there was some pooling on the canvas panel thats in front of the panel that has the separations as shown in the photo. I went under the cover to push up on the canvas a bit to drain the water off and it tore some more. The cover wasn’t super tight nor was it loose either. I usually have my cover on snugly. BTW, I’m in Wisconsin, the cover /boat is used outside from around May1st to around September 1st each year. Over the Winter, the boat and cover are stored inside my pole building with the cover loosely fit over the boat with the poles and snaps. My last boat had its original cover for 17 years with no tears or holes whatsoever. Has anyone else experienced premature failure like this and if so, how did Bennington or your dealer handle it? When we purchased the boat, I was concerned about the cover because of how lightweight it seemed and the lack of what I thought was proper reinforcing.