Recent content by Bob225

Mine is shown as Base Vinyl Sandstone and to me is a very light gray. Closer to a white than yellow. They replaced all the furniture and cup holders. The old cupholders that I kept match perfectly with the furniture.

Which way did you decide to go? I just looked and priced out 2024 Bennington 24 SLB and a 2024 Barletta 24 Cabrio UC. Both with a 250 (Yamaha SHO for Benny and Merc Verado for Barletta). Benny is about 15k more. I have been happy with our Bennington but not without issues. I like the layout...

Same issues here. Had dealer check the system out when they replaced the floor last year. Stated there was a kink in the line. Still have issues. I use the siphon hose but t stil spits out. Verfy frustrated.

I just dropped off the boat. Went with Bamboo Platinum. The new seats and tables are sandstone which is lighter but I think it will accent them well

Does it get hot?

We are getting the interior of the boat replaced under warranty. We need to select new flooring. Here are the 4 options. Do we want the tan color to match the seats/tables or do we want a contrast of silver/grey that compliment the black playpen metal panels?

I don't have any rattling issues either but a buddy with the same boat, 2 years newer, the doorway rattles on his.

I replace two on mine already. I asked the dealer about the snaps and she laughed and gave me a handful for free. Said they break all the time. I little tricky to get the new ones in but I have a friend that let me borrow his snap tool.

I added a JL 4 Channel amp and a WetSounds Stealth AS-10 with enclosure with built in amp. Used existing Kicker speakers. Amp really woke them up.

I think I will try this. I have checked every hose and there is no sag. I’m tired of dealing with this and gasoline spilling everywhere.

Under the helm and sounds really good. I assume you have an enclosure?

I just added a Wet sounds Stealth AS-10 with built-in amp. I ran the rear RCA's to the sub. You need to connect them to a 3.5 mm TRS female to dual RCA. This is on a 2016 with Sony DSX-M50BT. blue/white wire is REM out to turn the sub on.

that worked. Thank’s for the help!

Problem is that you have to remove that if your polishing the entire toon. Over the years the upper side got scummy for us. I’m sure the type of water you are in makes a big difference.