Plan on towing a minimum 4000 pounds. We have a 20ft tritoon and tow it with a GMC Acadia (v6) and it handles it just fine, but anything bigger and we would need something with a V8.
Here are a couple of my thoughts.
1. Check out this thread. I installed seagrass on my 2003 Bennington. If you can find a deal on the vinyl, it can be cost effective. http://club.benningtonmarine.com/threads/carpet-replacement.10002/
2. An old Bennington is nicer than a new sweetwater. We...
The wave shield is a factor because many of the bolts are just that, bolts. They have a nut on the back that is covered by the wave shield.
I had to take off everything bolted to the deck, so edge rail, seats, top rail, lights, etc. It was flat plywood. I put the helm on a piece of...
A couple other pieces of info. I have a Tritoon with under deck wave shield. The wave shield is riveted aluminum so in some spots, rather than remove the shield, I cut the bolts and replaced with screws. Only two spots I needed to do this was the two interiors screws on the console and the six...
I did take off my console. About six bolts. I did not remove the cabling or hydraulics. There was enough slack in the cabling to move the console around. I cut a hole in the sea grass and slice it so that I could slide it around the cabling, then I stapled it to the deck. It’s under the console...
Ok, I get terrible fuel economy. What would I want to change? Hole shot is good. Top end is good. All that said, this is my first boat, so I don’t have much else to gauge it to.
I currently have a 10 + year old 3 blade aluminum prop and i would like to replace with stainless. The current prop is sized correctly so I’m not looking to make any drastic changes. If I move to stainless and/or 4 blade, do I keep the same pitch? I am running a Yamaha 150 vmax 2 stroke on a...
I hope I didn’t scare anyone away. It was a lot of work, but totally worth it. People at our marina are shocked that our boat is a 2003. I’m sure I increased the value more than the $600 I spent on it. Also, we love it.
I just replaced the carpet on mine with seagrass vinyl. I purchased the vinyl as a “seconds” on Craigslist for $500. It had a defect which is covered by the seats. New seagrass would have been $1500-2500. The special marine glue to hold it down was $100. So, doing it myself cost about $600...
When I purchased my boat, someone had crashed the corner by the gas filler. I picked up a Replacement piece of sheet metal from restorepontoon.com. They only have a couple colors and black is one of them. Just uncrimp the back of fence and slide the new piece in. If you crack the crimps, use...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.